Car is dis-assembled, getting parts ready for finishing.

Still trying to keep this on track, currently the car is dis-assembled and I'm removing all the pieces to do all the stages of welding, cleaning, preping it for finishing. There are several large pieces that require a lot of welding, a lot of the alum and smaller pieces have been finished when it comes to welding, just putting them aside for cleaning/grinding and finishing. I'm going to do some more tubular work to the rear end........basically going to remove the whole strut towers and the square tubing stuff that I did a long time ago, when I'm done its going to look even more sexy than the front end came out. I had the idea a while ago but decided to not do it till I saw this picture that somebody had posted on Sixthsphere (saturn tuning board)

I've changed what/how I'm going to get the car blasted, I wanted to blast it right now, then bring it back for full welding, but I will run into problems with the car rusting as I'm welding it, requiring the car to be blasted again.....expensive and not needed step. I'm going to wire wheel the chassis where the welding needs to be completed, finish all the welding and then send it out for blasting and primer seal the car at the same time.

Here's a couple update photo's of where the car sits currently.